Follow these easy steps to get your Electrolux FAVORIT 33060 i Dishwasher up and running in no time.
Before using the dishwasher for the first time, remove all transport clips securing the dish racks.
Ensure that the water inlet and drain hoses, as well as the mains cable, are correctly connected beside the dishwasher. Open the water tap fully to allow water flow.
Plug the dishwasher into a power outlet. If the appliance is hard-wired, ensure it is safely isolated from the mains with appropriate disconnection switches, allowing a minimum contact separation of 3mm.
Install the dishwasher on a firm, level floor. Adjust the threaded feet using a screwdriver to ensure stability and alignment with surrounding units.
Adjust the water softener to prevent scale buildup. Follow the specific instructions for setting the correct level based on your water hardness.
Fill the special salt container to soften the water. This step is not required if you use 3-in-1 detergent tablets.
Fill the rinse aid dispenser to ensure dishes dry properly. Wipe any spilled rinse aid with a cloth.
Fill the detergent dispenser with the recommended amount of detergent. Close the lid until it locks into place.
Load cutlery and dishes into the dishwasher. Ensure that sponges, household cloths, or any water-absorbing objects are not included.
Turn the programme selector to choose the appropriate wash programme based on the soil level of the dishes.
Close the dishwasher door and start the selected wash programme by turning the programme switch.